This alternative charging method may be used when access to an AC outlet is unavailable. Always fun to learn about why things break. Charging using the supplied 12 Volt Male-Male Extension Cord. So the low charging current of 250mA might be right. But he spec says ~30 hours is full-charge time. This auction is unavailable for bids and/or shipping outside of the Continental United States.
#Super start power pack 12 volt portable#
Also was unclear if 250mA is the correct charging current. Super Start Power Pack Portable Power Source. Check for a loose connection at the battery terminal before buying a new battery. With the loose connection, and the lamp turned on, the light provide the load, even with the battery terminal disconnected.Īfter tightening the battery connection current stayed on regardless of whether the light was on or not, because now the battery provided the load, when the lamp was off. Circuit can only be reset by unplugging and plugging back in. With no load the circuit must sense no load and shut the charging circuit down. Fully charges in 5 hours and can hold a charge for. With the loose terminal and no light on there was zero current being drawn from the power supply circuit of the charger, and no load on the circuit output 9since the battery term was loose (intermittent open). POWERFUL LIFE SAVER: This GOOLOO emergency jump starter has enough power (800A peak current) to jump start most 12 volt vehicles on the road (up to 7.0L gas or 5.5L diesel engines) Works with cars, motorcycles, watercrafts, ATVs, UTVs, SUVs, lawn mowers, yachts, boat, pickup,snowmobiles, etc. No current).Ĭlipped lead back on (still plugged in). 750 Peak Amp Jump Starter with Compressor features 375 amps of starting power that. Then unclipped one lead breaking the circuit between the charging circuit and the battery. The OPTIMA Chargers Digital 1200 12V Performance Battery Charger and. Then unplugged then connected and amp meter between one wire (+) the circuit card and the battery. Cycled power (unplug unit from the wall then plugged back in) turned LED back on. Power adapter at the back on the AC input was providing 17VDC at the circuit card yet the LED was not lit. Disconnected the heavy red and Black cables from the battery and left only the two wires from the charging circuit card connected.
After opening the back found the + terminal was found loose. Unplugged then plugged in Lamp on Bright LED charge indicator light on. Instant Starting Amps Stanley Tools - AIRPRO 120 PSI 12V Inflator - CDC120S Stanley Tools - POWERiT 1200 Peak Amp Jump StarterPower Station - J5CPD Stanley. Unplugged from outlet plugged back in no light. And when turning the lamp on again, Lamp stayed dim. If I turned off the lamp the LED light went out. No red LED charge indicator light unless I turned the lamp on. Then tried to charge it up and wouldn't take a charge. Found the battery was not the issue.īack ground: Like most people I used it a couple of times.
0 kommentar(er)
